Spacers for front end

I started to do spacers for front end. It took me about 4 hours to make one...BUT. I had problems with tool post of lathe etc. Anyway. Point here is, that I really need practice with lathe. This was good job for learning of using it and maybe someday I will be faster & better. In any case, I am quite satisfied with the results. One more to go!

Starting point & final piece. Made from 28mm solid axle steel bar. It turned to 17mm (outside) & 12mm (inside) spacer.

The Spacer in It´s full Glory

 

I did this inside neck, so it dwells into it´s place.

There It sits!