Trying to make a sissybar

Now I am at that point, that I can start to make a sissybar. I have never done this before, but have readed instructions from web. It is quite straightforwarded. You heat metal bar and then bend it! Of course there is lot of things, which I should learn, but I am pretty satisfied about this testing prototype. Have to buy more steel bar (in this case 13mm axle steel) and try to make taller one tomorrow.

Trying to straighten it at start. Should have done first bend at stable metal table.

In any case, it went quite well. This is not just tall enough.

At this pic I have already made those bends, which go over wheel.

Prototype ready.